Bosch UniversalRotak 470 Instructions Manual page 14

14 | English
Never touch the mains plug with wet
u
hands.
Do not run over, crush or pull the
u
power supply cord or extension
cord, otherwise it may be damaged.
Protect the cable from heat, oil and
sharp edges.
The extension lead must have a cross
u
section in accordance with the oper-
ating instructions and be protected
against splashed water. The connec-
tion must not be in water.
Always wear gardening gloves
u
when handling or working near the
sharp blades.
Electrical Safety
Warning! Switch the
product off and pull the
mains plug before any main-
tenance or cleaning. The same ap-
plies when the mains cable is dam-
aged, cut or entangled.
The blade continues to rotate for a
u
few seconds after the machine is
switched off.
Caution do not touch the rotating
u
blade.
Your product is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V
AC, 50 Hz (for non-EU countries
220 V, 240 V as applicable). Contact
your Bosch Service Centre for details.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service
Centre.
1 609 92A 5W7 | (15.07.2020)
For increased electrical safety use a
Residual Current Device (RCD) with a
tripping current of not more than
30 mA. Always check your RCD every
time you use it.
Keep the supply cables away from
moving hazardous parts and avoid
damage to the cables; this can lead to
contact with live parts.
The connections (plugs and sockets)
should be kept dry and off the ground.
The supply cables must be inspected
for signs of damage at regular intervals
and may only be used if in perfect con-
dition.
If the supply cable on the product is
damaged, it must only be replaced by
a Bosch Service Centre. Only use ap-
proved extension cables.
Use only extension cords, cables,
leads and cable reels that comply with
EN 61242/IEC 61242 or IEC
60884-2-7 and are of type H05VV-F
or H05RN-F.
If you want to use an extension cable
when operating your product, only the
following cable dimensions should be
used:
– Nominal conductor area of
2
1.25 mm or 1.5 mm
– Maximum length 30 m for a Cord
Extension Set or maximum length
of 60 m for a Cable Reel with Re-
sidual Current Device (RCD).
Note: If an extension cable is used it
must be earthed and connected
through the plug to the earth cable of
2
Bosch Power Tools