Download Print this page

JBL DCR600II Service Manual page 75

A/v dolby digital receiver cinema propack 600ii system
Hide thumbs Also See for DCR600II:

Advertisement

DCR600II
Description (Continued)
The AT27LV010A is available in industry standard
JEDEC-approved one-time programmable (OTP) plastic
PLCC and TSOP packages. All devices feature two-line
control (CE, OE) to give designers the flexibility to prevent
bus contention.
The AT27LV010A operating with V
TTL level outputs that are compatible with standard TTL
logic devices operating at V
capable of standard 5-volt operation making it ideally
suited for dual supply range systems or card products that
are pluggable in both 3-volt and 5-volt hosts.
Atmel's AT27LV010A has additional features to ensure
high quality and efficient production use. The Rapid
gramming Algorithm reduces the time required to program
the part and guarantees reliable programming. Program-
ming time is typically only 100 µs/byte. The Integrated
Product Identification Code electronically identifies the de-
vice and manufacturer. This feature is used by industry
standard programming equipment to select the proper
programming algorithms and voltages. The AT27LV010A
programs exactly the same way as a standard 5V
AT27C010 and uses the same programming equipment.
at 3.0V produces
CC
= 5.0V. The device is also
CC
Pro-
System Considerations
Switching between active and standby conditions via the
Chip Enable pin may produce transient voltage excur-
sions. Unless accommodated by the system design, these
transients may exceed data sheet limits, resulting in de-
vice non-conformance. At a minimum, a 0.1 µF high fre-
quency, low inherent inductance, ceramic capacitor
should be utilized for each device. This capacitor should
be connected between the V
the device, as close to the device as possible. Additionally,
to stabilize the supply voltage level on printed circuit
boards with large EPROM arrays, a 4.7 µF bulk electrolytic
capacitor should be utilized, again connected between the
V
and Ground terminals. This capacitor should be posi-
CC
tioned as close as possible to the point where the power
supply is connected to the array.
75
and Ground terminals of
CC

Advertisement

loading