Cleaning Modes - Shark VERTEX AZ1500WM Series Owner's Manual

WHOLE-HOME CLEANING
POWER
Press power button to turn on vacuum.
Please note the Brushrolls will not spin
unless the wand is reclined.
BRUSHROLL INDICATOR LIGHT
INDICATOR LIGHT
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushrolls are spinning and working as they should.
Solid Red: There is a jam in the brushroll area. Turn your vacuum off and remove any blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn off the vacuum, unplug it, and remove any
blockages. Let the vacuum cool down for at least 60 minutes before restarting. See Troubleshooting
section for more information.
Flashing Green: The vacuum is operating in an environment that is either too hot or too cold. This vacuum
will only function properly in temperatures ranging from 32°F (0°C) to 104°F (40°C). Turn the vacuum off
and adjust the room temperature. Once the temperature has reached the operating range, turn the vacuum
back on.
NOTE: Brushrolls spin in all modes.
s h a r kc l e a n . c o m
SETTINGS
SURFACE SETTINGS
Choose the appropriate setting.
Thick Carpet & Area Rug Cleaning
Set surface selector to Thick Carpet/Area Rug for
improved maneuverability on high pile carpet.
Carpet & Low Pile Cleaning
Set surface selector to Carpet/Low Pile to increase
the speed of the brushrolls and to help remove
stuck-on dust and debris.
Hard Floor Cleaning
Set surface selector to Hard Floor.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt
in carpets) please set to Carpet/Low Pile. For particularly
stubborn stuck-on dust messes, set to Carpet/Low Pile mode.
WHOLE-HOME CLEANING

CLEANING MODES

UPRIGHT
To engage brushrolls, turn on
power, then step on floor nozzle
and tilt handle back.
Handle
ABOVE-FLOOR—HANDLE
Press the Handle button to detach
the handle from the wand.
Wand
Release
ABOVE-FLOOR—WAND
Press the Wand Release button
to detach the wand from the pod.
NOTE: All accessories are compatible with both the wand and the handle.
POWERED LIFT-AWAY®
Press the Lift-Away button to
detach the pod from the floor nozzle.
Handle
LIFT-AWAY—HANDLE
With pod removed, press the
Handle button to detach the
handle from the wand.
Wand
Release
LIFT-AWAY—WAND
With pod removed, press the
Wand Release button to detach
the wand from the floor nozzle.
s h a r kc l e a n . c o m