Transmission/Primary Fluid - Buell P3 2003 Service Manual

HOME

TRANSMISSION/PRIMARY FLUID

GENERAL
The transmission should be drained and refilled with fresh
fluid:
At the 1000 mile (1600 km) initial service and at every
5000 (8000 km) service interval thereafter.
Transmission fluid capacity is 1.0 quart (0.95 liter). For best
results, drain fluid while it is hot.
INSPECTION
1. Remove seat. See 2.28 SEAT.
11 1
WARNING
To protect against shock and accidental start-up of vehi-
cle, disconnect the negative battery cable before pro-
ceeding. Inadequate safety precautions could result in
death or serious injury.
2. Disconnect negative battery cable from battery.
3. Remove left footpeg support bracket. See
PEGS AND FOOTPEG SUPPORT BRACKETS.
7667
1
1. Torx screws with washers (3)
2. Clutch inspection cover
3. Magnetic drain plug (with o-ring)
Figure 1-15. Primary Cover
4. See Figure 1-15. Remove three TORX screws with
washers (1) from clutch inspection cover (2). Remove
clutch inspection cover from primary cover.
WARNING
2.21 FOOT-
2
3
a0126x6x
1
2
1. Adjusting screw
2. Cable end
3. Coupling
4. Correct fluid level
Figure 1-16. Fluid Level
5. See Figure 1-16. Inspect fluid level with motorcycle in
upright position.
6. See Figure 1-15. Install clutch inspection cover using
three TORX screws with washers. Tighten in a crosswise
pattern to 84-108 in-lbs (9.5-12.2 Nm).
7. Install left footpeg support bracket. See
PEGS AND FOOTPEG SUPPORT
8. Connect negative battery cable to battery. See
TERY.
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control and personal injury.
9. Install seat. See 2.28 SEAT.
2003 Buell P3: Maintenance
1.10
3
4
2.21 FOOT-
BRACKETS.
1.4 BAT-
WARNING
1-19