Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co.,Ltd.
Chapter 9 PC Configuration Instructions
The following picture shows the E22-230T30D configuration host computer display interface, the user can switch
to command mode through M0 and M1, and quickly configure and read parameters on the host computer.
In the configuration of the host computer, the module address, frequency channel, network ID, and key are
all displayed in decimal; the value range of each parameter is as follows:
Network address: 0～65535
Frequency channel: 0～83
Network ID: 0～255
Key: 0～65535
When using the host computer to configure the relay mode, users need to pay special attention, because in
the host computer, each parameter is displayed in decimal mode, so the module address and network ID need
to be converted into decimal when filling in;
If the network ID input by transmitter A is 02, and the network ID input by receiver B is 10, then when relay
Copyright ©2012–2020，Chengdu Ebyte Electronic Technology Co.,Ltd.
20
E22-230T30D User Manual
Advertisement
Table of Contents
