Technical Specifications - Maxwell MW-4070 Manual Instruction

«II» – medium power level 900 W, for medium-
sized rooms;
«I + II» – high power level 1500 W, for large rooms.
• When the room temperature reaches the required
value, slowly turn the thermostat control knob (4)
counterclockwise until the light indicator in the
switch (5) goes out. The preset temperature will
be maintained automatically.
• After the unit operation is finished, turn the ther-
mostat control knob (4) counterclockwise as far
as it will go and set the operation mode switch (5)
to the off-position «0» and unplug the unit.
Note: – the light indicators in the switches (5) will
light up only if the room temperature is less than the
temperature preset by the thermostat knob (4).
• There should be good heat insulation in the room
where the oil heater is used, otherwise you will
not get the desired results of the oil heater opera-
tion, due to cold air flow.
• The ventilation openings on the oil heater body
should be well-aerated otherwise the thermostat
may operate improperly.
• When moving the oil heater hold it by the han-
dle (6).
PROTECTION FROM DROPPING
– If the oil heater is accidentally dropped, the
blocking device will be switched on and the oil
heater will be switched off.
– Put the oil heater back to the vertical position, the
unit will be switched on.
Note: – place the oil heater on a flat dry and steady
surface to prevent it from dropping.
CLEANING AND CARE
– Periodically wipe the front panel (3) and do not
allow dust to accumulate in the ventilation open-
ings.
– Switch the oil heater off and unplug the power
cord plug from the mains socket, let the unit cool
down and wipe the body (7) with a damp cloth;
then wipe it dry.
– Do not use abrasives or solvents for cleaning the
oil heater.
– Avoid leaving scratches or dimples on the fins
surface, this may cause rusting and early break-
down due to oil leakage.
– After cleaning the heater wind the power cord
around the cord storage (2) and fix it in the
lock (1). Use the original package and put the oil
heater away for storage in a dry cool place away
from children and disabled persons.
– Before using the oil heater next time, it is rec-
ommended to check the heater body for dam-
ages, check the integrity of the power cord
isolation and the power cord plug and the unit
operability.
DELIVERY SET
Oil heater – 1 pc.
U-shaped mount – 2 pcs.
Plate – 2 pcs.
Wheel – 4 pcs.
Instruction manual – 1 pc.
Warranty certificate – 1 pc.

TECHNICAL SPECIFICATIONS

Power supply: 220-240 V ~ 50 Hz
Rated power consumption: 1500 W
Power range: 600/900/1500 W
Area of the heated room: up to 15 sq.m.
RECYCLING
For environment protection do not throw out the unit
and the batteries (if included), do not discard the unit
and the batteries with usual household waste after
the service life expiration; apply to specialized cen-
ters for further recycling.
The waste generated during the disposal of the unit is
subject to mandatory collection and consequent dis-
posal in the prescribed manner.
For further information about recycling of this prod-
uct apply to a local municipal administration, a dis-
posal service or to the shop where you purchased
this product.
The manufacturer preserves the right to change
design, structure and specifications not affecting
general principles of the unit operation without a
preliminary notification due to which insignificant dif-
ferences between the manual and product may be
observed. If the user reveals such differences, please
report them via e-mail info@ m axwell-products.ru for
receipt of an updated manual.
Unit operating life is 3 years
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appliance
was purchased. The bill of sale or receipt must be
produced when making any claim under the terms
of this guarantee.
This product conforms to the EMC
Directive 2014/30/EU and to the Low
Voltage Directive 2014/35/EU.
9
ENGLISH