Table of Contents
Advertisement
Your heater needs very little maintenance, but the following information will help you to keep it looking
good and working efficiently.
Unplug before cleaning.
All parts of the heater can be cleaned using a soft, damp cloth.
IMPORTANT
DO NOT use solvents to clean any parts.
DO NOT spray aerosols in the vicinity of this appliance while it is in operation.
DO NOT place articles on or against this appliance.
DO NOT use or store flammable materials in or near this appliance.
AIR FILTERS
Dusty filters reduce heating effectiveness.
DO NOT wait for Filter indicator
cleaning filters.
DO NOT use the heater with the filter warning lamp on. This
may cause it to overheat.
REMOVING FILTERS
Filters require cleaning at least once a week during the heating
season to prevent blockages.
For cleaning Filter 1
7
(ensure the retaining screw is stored in a safe place).
Carefully lift filters up then backwards to remove from locating
tabs.
With the careful use of a vacuum cleaner, gently remove any
contaminates such as dust and lint.
Replace filters by carefully repositioning the location tabs and
fasten in place with the retaining screw.
Filter 2
(the small filter) should be left in position for
8
cleaning, carefully use a vacuum cleaner to remove any
contaminates such as dust and lint.
SERVICE
Rinnai recommend that this appliance be inspected and
serviced every 2 years.
If the power supply cord or any other component of the heater are damaged, they must be replaced
by Rinnai or a suitably qualified person.
Any service or repair work should only be carried out by an authorised person. Rinnai has service and
spare parts departments nationally see back cover for contact details.
Service calls for general cleaning, maintenance and wear and tear are not necessarily
covered under the warranty. Service calls of this nature may be chargeable.
NOTE
Faults caused by insufficient gas supply, gas quality, installation errors or operation
errors are not covered by the Rinnai warranty.
Rinnai
CARE AND MAINTENANCE
to come on before
30
, undo and remove the retaining screw
8
7
8
7
17
Operation Manual
Advertisement
Table of Contents
