Table of Contents
Advertisement
4.5.2.4 Serial Telnet mode
Telnet (TELecommunication NETwork) is a network protocol used on the Internet or local area network (LAN) connections. The
Telnet protocol type is the correct setting for most servers and serial devices, such as Managed Ethernet switches or Gateways.
In the case of a Telnet session, the process is reversed, where the connected server reads and writes data to RS-232 serial port.
Once the serial Telnet application is enabled, the industrial serial server will interact with these special CR/LF commands. The
serial telnet mode topology in
The serial Telnet mode screenshot in
Object
• TCP Keep-alive
Interval
• Quiescent Time
• Local TCP port
• Translate CR-LF
User's Manual of ICS-2x00T Serial Device Server Series
Figure 4-5-9
appears.
Figure 4-5-9: Serial Telnet Mode Topology
Figure 4-5-10
appears.
Figure 4-5-10: Serial Telnet Mode Screenshot
Description
TCP keep alive interval shows how many seconds the unit waits during an inactive
connection before checking its status. If the unit does not receive a response, it will drop
that connection. The default is 0 minute.
When the network connection is determined to be idle, the duration of the control
network inactivity will cause the connection to be forced closed. The range of value is
from 1 to 65535 ms. The default is 0 ms
This parameter describes the TCP port that communicates with the connected device.
The setting slave and master destination IP parameters must use the same value to
achieve communication. The range of value is from 1 to 65535. The default is 5004 for
port 1, 5005 for port 2, 5006 for port 3 and , 5007 for port 4
Enter CR-LF characters can be processed after industrial serial server. Just send CR, or
LF, or do not modify CR-LF character. The default is CR-LF.
CR-LF
CR
LF
51
Advertisement
Table of Contents
