Samson 44-0 B Mounting And Operating Instructions page 7

Responsibilities of operating personnel
Operating personnel must read and understand these mounting and operating instructions as
well as the referenced documents and observe the specified hazard statements, warnings
and caution notes. Furthermore, operating personnel must be familiar with the applicable
health, safety and accident prevention regulations and comply with them.
Referenced standards, directives and regulations
The regulators comply with the requirements of the European Pressure Equipment Directive
2014/68/EU. Regulators with a CE marking have an EU declaration of conformity, which
includes information about the applied conformity assessment procedure. This EU declaration
of conformity is included in the 'Certificates' section.
According to the ignition risk assessment performed in accordance with Clause 5.2 of
ISO 80079-36, the non-electrical regulators do not have their own potential ignition source
even in the rare incident of an operating fault. As a result, they do not fall within the scope of
Directive 2014/34/EU.
Î For connection to the equipotential bonding system, observe the requirements specified in
Clause 6.4 of EN 60079-14 (VDE 0165-1).
Referenced documentation
The following documents apply in addition to these mounting and operating instructions:
− Mounting and operating instructions for
e.g. Type 1 NI Strainer
− Data sheets for
e.g. Type 1 NI Strainer
− Mounting and operating instructions as well as data sheets for additional fittings
(e.g. shut-off valves, pressure gauges etc.).
EB 2626-1 EN
Safety instructions and measures
u EB 1010
u T 1015
1-3