Nubert nuGo! ONE Quick Start Manual

Hide thumbs Also See for nuGo! ONE:

nuGo! ONE Bluetooth Speaker

1 Charging

Please make sure before putting into operation that the battery of the

nuGo! ONE is charged enough. The battery charge level is shown in the

display when the device is in operation. If the battery level is low, it must

be charged as follows:

QUICK START GUIDE

On the back side there is a plastic cover

with some technical connections behind.

Connect the USB-C jack on the left with the

included power supply unit.

⚠

Notice:

▪ To ensure splash water protection of the

device, the plastic cover must be closed

tightly after it has been recharged.

Table of Contents

Do you have a question about the nuGo! ONE and is the answer not in the manual?

Page 1 Please make sure before putting into operation that the battery of the nuGo! ONE is charged enough. The battery charge level is shown in the display when the device is in operation. If the battery level is low, it must...
Page 2 2 Switching on and off By pressing the button the loudspeaker can be activated or turned off. Press this button for 1 second as minimum for turning off the nuGo! ONE. 3 Main Menu Press and hold the rotary control for 3 seconds to switch into menu while the operating display works permanently.
Page 3 6 Bluetooth mode By rotating the rotary control knob, you could set the volume level. When pairing with another device firstly, the nuGo! ONE is looking for a suitable device automatically. For pairing another device, press the rotary control knob two times suc- cessionally.
Page 4 Service If you may have any questions about your new Nubert product or some problems with putting into operation, you could gladly contact our Ser- vice Team. Please hold ready your customer number. _______________________________________________________________________ Technical changes and misprints reserved. You will find the newest instructions for use and more information about this product here: http://www.nubert.de/...