Related Manuals for Hall Technologies HT-CALIPSO
Summary of Contents for Hall Technologies HT-CALIPSO
- Page 1 Hall Technologies • 1234 Lakeshore Dr Suite #150 Coppell, TX 75019 • halltechav.com HT-CALIPSO All-in-one meeting collaboration bar. API Command List Version: 1.0 Hall Technologies March 30, 2023 Page 1 of 10...
-
Page 2: Table Of Contents
COMMAND LIST TABLE OF CONTENTS Connecting to the HT-CALIPSO ........................3 IP Address ............................3 Enabling Telent Client ........................3 Logging in Via Command Prompt ....................4 Terminology & API Commands Overview ....................5 Terminology ............................ 5 API Commands Overview ....................... 5 API Commands ............................ -
Page 3: Connecting To The Ht-Calipso
If needed, change the IP address on your PC to be in the same IP range and same subnet as the HT-CALIPSO. You can find out the IP address of the HT- CALIPSO by looking in the bottom right corner of the Guide Screen (you will need to connect the HT- CALIPSO to a display). -
Page 4: Logging In Via Command Prompt
4. The device will display a # as the command prompt. The device is now ready to execute the API commands. username : admin password : Welcome to HT-CALIPSO. ~ # | Hall Technologies March 30, 2023 Page 4 of 10... -
Page 5: Terminology & Api Commands Overview
This example changes the device’s configuration to be “normal” for the mode of the camera. Note: For the “show” command there is only a single dash: gbconfig -s camera-mode Hall Technologies March 30, 2023 Page 5 of 10... -
Page 6: Api Commands
--get-cascade-mic- Displays the total number of cascaded HT-Satellite-EXT online-num microphones connected to the HT-CALIPSO. Changes the camera’s tracking mode. Normal: User’s adjust the pan, tilt, zoom manually. {normal | autoframing Auto Framing: The camera automatically tracks the people... - Page 7 -s anc Displays the ANC state. Enables (y) or disables (n) AGC (Automatic Gain Control) on gbconfig --agc {y | n} the microphones. gbconfig -s agc Displays the AGC state. Hall Technologies March 30, 2023 Page 7 of 10...
-
Page 8: Gbcontrol Commands
Displays information related to the current screen layout. Adding detail to the command provides the position and gblayout --get detail size of every window and the video source displayed in the window. Hall Technologies March 30, 2023 Page 8 of 10... -
Page 9: Events
[Event] WorkMode This message means that the device’s work mode has changed. This message means that the screen layout has changed and includes the [Event] Layout layout ID and its name. Hall Technologies March 30, 2023 Page 9 of 10... - Page 10 © Copyright 2022. Hall Technologies All rights reserved. 1234 Lakeshore Drive, Coppell, TX 75019 halltechav.com / support@halltechav.com (714)641-6607 Hall Technologies March 30, 2023 Page 10 of 10...