Hall Technologies HT-CALIPSO Manual page 7

gbconfig -s hdcp-enable
gbconfig --cec-enable
gbconfig -s cec-enable
gbconfig --sinkpower
gbconfig --cec-cmd hdmi
gbconfig -s cec-cmd
gbconfig --send-cmd hdmi
gbconfig --mic-mute
gbconfig -s mic-mute
gbconfig --autovolume
gbconfig --aec
gbconfig -s aec
gbconfig --anc
gbconfig -s anc
gbconfig --agc
gbconfig -s agc
Hall Technologies March 30, 2023
HDCP22: Sets HDCP to 2.2
Displays the status of the HDCP for HDMI output.
{y | n} Turns on (y) or off (n) CEC mode.
Displays the status of CEC mode.
Turns on/off the ability to send a CEC command to the
{on | off}
display to turn it on/off.
Enters the command string to turn on/off the connected
display.
{on | off} {CmdStr}
CmdStr: The CEC command in string or hex format. For
example, the command to turn on the display could be "40
04": CmdStr = 4004
Displays the command set for the on/off command.
Tests CEC commands to turn displays on/off. This is only for
{CmdStr}
testing and is not stored to the device.
Sets all microphones, including cascaded microphones, to
{y | n}
mute on (y) or off (n).
{y | n} Displays the status of the microphone mute state.
Increases or decreases the volume. Each increase/decrease
{inc | dec}
is 2 level steps.
Enables (y) or disables (n) AEC (Acoustic Echo Cancellation)
{y | n}
on the microphones.
Displays the AEC state.
Enables (y) or disables (n) ANC (Active Noise Cancellation)
{y | n}
on the microphones.
Displays the ANC state.
Enables (y) or disables (n) AGC (Automatic Gain Control) on
{y | n}
the microphones.
Displays the AGC state.
Page 7 of 10