Table of Contents
Advertisement
Available languages
Available languages
CLEANING
Wipe down or wipe out the outside and inside with a damp, soft cloth. You can use a light cleaning agent. Do not use any sharp,
bleaching, caustic or scratching cleaning agents/cleaning aids, as this could damage/scratch the surfaces.
Clean the storage container and the water tray daily.
Clean the ventilation slots from time to time, as dust and dirt can block the slots. To do this, remove the plastic cover on both
sides by loosening the screws. Clean everything with a soft brush or hand brush. In addition, use a hoover.
MAINTENANCE
The cooling unit requires little maintenance. Check the ventilation slots for dirt. Brush with a soft brush and at the same time
vacuum the dirt with a vacuum cleaner, see Cleaning.
You can descale the machine in between. Remove the strainer from the drain and clean it. Put the sieve back in place. You can
then fill the descaler with water into the reservoir and let the machine run for 3-4 production cycles. Drain the descaler and rinse
the machine with fresh water. When no descaler is visible, run it through 4-5 production cycles and discard the ice cubes.
A complete maintenance and disinfection of the unit is recommended once a year or after a longer shutdown. Contact your
dealer for this. This cleaning must be carried out by a technician.
STORAGE/ TRANSPORT
Switch off the unit, disconnect the mains plug.
Clean the appliance thoroughly inside and out and open the door to allow the appliance to dry sufficiently.
If it is dry and the unit is not to be used for a longer period of time, store it in a dry, dust-free and not hot place. It is best to cover
the unit or use the original packaging to protect the unit from damage.
When storing only the packaging material, please note that components of the packaging such as plastic bags, cardboard,
polystyrene parts, etc., can be dangerous for children if they play with them unsupervised (e.g. choking hazard). can endanger
children if they play with them unsupervised (e.g. choking hazard).
When transporting the unit, it is best to use the original packaging so that the unit is optimally protected against impact, sharp
edges, weather conditions, etc. Do not tilt the unit more than 45 degrees and do not expose it to moisture or rain and avoid
strong vibrations. After transport, the unit must stand for approx. 24 hours without further movement before it can be
reconnected. Otherwise, a defect may occur as the refrigerant and oil must be distributed/placed correctly again.
TROUBLESHOOTING
Problem
No cooling
Unsatisfactory
performance
Strong noises
The unit does not work
The compressor does not work
Stand 05/23 SvN
Cause and solution
Is the plug inserted? Is the socket in order? Is the fuse defective? Power failure? Thus
realise the power supply of the unit again.
cooling
Direct sunlight? Is there a heat source nearby? Is the ventilation of the environment poor?
Does the flap close properly? Is the damper bar deformed or damaged? Is the condenser
clean?
The unit is not properly levelled.
The unit is touching the wall or other objects. Something is loose on the unit.
Correct the safe, straight stance and/or remove the touches.
Switch the unit off, wait 5 minutes, switch it on again.
Ambient temperature below 10°C? Put the unit back into operation when the ambient
temperature is higher.
Reservoir full?
Seite 27 von 33
Advertisement
Chapters
Table of Contents
