Table of Contents
Advertisement
Available languages
Available languages
GENERAL NOTES
•
Keep these operating instructions within easy reach near the unit.
•
The manufacturer/dealer cannot be held responsible for damage caused by failure to observe these operating
instructions.
•
If these operating instructions are not observed, the safety of the appliance is no longer guaranteed.
•
If the unit is passed on to third parties, these operating instructions must also be handed over.
•
This appliance must not be operated by children or persons with reduced physical, sensory or mental capabilities, as
they may not understand the hazards involved in the use of electrical appliances and/or refrigeration appliances,
resulting in accidents, fire, explosion or property damage.
•
After unpacking the unit, make sure that everything is in perfect condition. If you discover any damage, do not connect
the unit but notify your dealer.
•
Check whether all components specified in the scope of delivery are present. If this is not the case, inform your dealer.
•
Keep the packaging of the unit. The unit can only be transported safely in its original packaging, e.g. for repair
purposes, when moving house, etc. Note that all components of the packaging (plastic bags, cardboard, polystyrene
parts, etc.) can endanger children and must therefore not be stored near them.
•
If it is not possible to store the packaging, separate the different packaging materials and deliver them to the nearest
collection point for proper disposal.
•
Do not use the unit outdoors in the rain or in damp rooms.
•
Do not operate the unit unattended.
•
Observe the accident prevention regulations and general safety regulations applicable to the area of use.
•
Place the unit in a dry, adequately ventilated place and on a straight, safe surface.
•
Ensure at least 10 cm distance between the back of the unit and the wall. Otherwise, the desired cooling performance
can no longer be guaranteed.
•
Do not place the appliance near heat sources such as heaters, cookers, ovens or open fires or in direct sunlight, as the
desired cooling capacity can then no longer be guaranteed.
•
The ventilation slots must always be kept clear and must not be covered or obstructed.
•
Before commissioning, observe the recommended ambient temperatures (climate class) of the appliance for optimum
cooling performance
•
Before connecting the appliance to the mains and before using it, clean it carefully as indicated under "Cleaning".
•
Before connecting the appliance, make sure that a shockproof socket (with earth) and a 230 volt connection are
available and that this corresponds to the information on the type plate. Other types of current than specified on the
type plate may cause the appliance to overheat or become defective.
•
Do not drill or pierce holes in the inside or outside of the unit. The cooling circuit could be damaged.
•
During the period of use, daily cleaning is recommended for hygienic reasons.
•
Always disconnect the appliance from the mains before cleaning, switch off the appliance beforehand if it has an on/off
switch; the same applies if the appliance will not be used for a long time.
•
The manufacturer/dealer cannot be held responsible for damage caused by failure to observe the operating
instructions. Likewise, the safety of the unit is then no longer guaranteed.
•
In the event of a malfunction, disconnect the appliance from the mains and inform your dealer. He will carry out the
repair with original spare parts.
•
The ice cubes are slightly milky.
•
If the water hardness is 7°C or higher, an upstream water hardener is recommended.
•
The appliance does not have a waste water pump, make sure that there is a slope between the appliance and the drain.
The water drainage hose should run below the lower edge of the appliance so that the water can drain off easily
SAFETY INSTRUCTIONS
•
Incorrect operation and improper handling can lead to malfunctions of the unit and injury to the user.
•
The appliance is neither suitable nor intended for the storage of medicines or highly flammable, combustible or
explosive substances.
•
Observe the accident prevention regulations and general safety regulations applicable to the area of use.
•
Ensure that the unit stands securely on a dry, non-slip surface that is adequate for the weight of the unit and that it is in
a well-ventilated place.
•
Do not expose the appliance to direct sunlight, do not place it near other heat sources (heater, cooker, oven... open fire)
and/or do not place it on a hot surface, otherwise the desired cooling capacity cannot be achieved.
•
Do not store highly flammable or explosive substances near the unit.
Do not carry out any work with highly flammable substances in the vicinity of the unit (no spray paint or similar). It could
Stand 05/23 SvN
Seite 23 von 33
Advertisement
Chapters
Table of Contents
