Connection; Structure And Parts - saro EB 26 Operating Instructions Manual

CONNECTION

After prolonged transport, the unit should only be put into operation after 24 hours, as well as after
strong inclination; that the cooling circuit stabilises again, refrigerant distributes evenly again
in order not to cause a defect, a malfunction.
After short movement and inclination below 45 degrees, please wait 2 hours before connecting.
Before connecting the unit, make sure that the voltage and frequency of the power supply match the specifications on the type
plate! Other voltages can cause the unit to overheat!!!
Only connect the appliance to an earthed socket outlet with a 230 volt connection.
After a power failure or if the unit has been disconnected from the mains, wait at least 5 minutes before reconnecting the unit
and putting it into operation!
If the unit is restarted immediately after it has been switched off, the fuse may blow and interrupt the flow of electricity. In addition,
the compressor may be overloaded and damaged.

STRUCTURE AND PARTS

Stand 05/23 SvN
After delivery or transport of the unit, connect it only after the unit has been at rest for at least 24 hours.
This is absolutely necessary so that the refrigerant can collect in the compressor.
Seite 25 von 33