Product Overview - Iridium LED WASH PRO 44WS 44x20W Manual

Introduction
Packaging:Thanks for your purchasing the LED WASH PRO 44WS. All the lights have
been checked and are in excellent operating condition. Please check the shipping carton
first,because there may be damage occurred during the shipment.Then check the lights
carefully and be sure that the lights is intact and works normally.In the event damage has
been found, spare parts are missing or the lights works abnormally,please contact us for
further instructions. And please don't return the lights to the dealer before contacting us.
Introduction:The LED WASH PRO 44WS. has three operating modes:DMX mode, Auto
mode and Master/Slave mode.And the lights has five DMX modes,including channel
2,channel 3 , channel 4, channel 9 and channel 12.There are twenty-one built-in Auto
programs and you can see twenty-one kinds of shows when you open the Auto
mode.Meanwhile, you can edit your desired Auto program in "EDIT" menu.In addition,
you can connect several pieces of lights in DMX mode and set one in Auto mode, and the
others in Master/Slave mode.And then all the lights in Master/Slave mode will run
following the one in Auto mode.Using fog or special effect smoke,you can see better
showing effect.
Warning!
1.Don't expose the lights to rain or moisture,for the sake of preventing the risk of
electrical shock or fire.
2.Don't look directly at the opening lights all the time,or it may damage your eyes.

Product Overview

Connection
Master / Slave connection
Wireless connection
POWER DMX OUT
DMX IN POWER
Press "ENTER" button and then "UP" or "DOWN" button until "SET UP" is showed.
Press "ENTER" button and then "UP" or "DOWN" button until "Wirless rel" is
displayed, press ENTER button. Then press DMX Mode is ok.
Then, until Green wireless signal is displayed. Then Wireless DMX connected
success.
About the condition of wireless signal, Green represents the successful setting, while
red represents the signal is unsuccessful.
Release wireless DMX signal
Press "ENTER" button and then "UP" or "DOWN" button until "Wirless rel" is showed.
Press "ENTER" button and then "UP" or "DOWN" button until "press +/-" is
displayed, press "UP" or "DOWN" button, long press "UP" or "DOWN" button about
5-6 seconds. Until "Initialization" to "Release finish" is displayed. It means release
signal successfully.
3
DMX address: 001
ID address: 01
14