Procedure To Program Ez-Pd™ Ccg7Dc-Based Daughter Board - Infineon EZ-PD PAG1S-1P User Manual

EZ-PD™ PAG1S-1P based 65 W ATQ GAN USB PD dual-C charger
and adapter solution user guide
Procedure to program EZ-PD™ CCG7DC-based daughter board
4 Procedure to program EZ-PD™ CCG7DC-based daughter board
EZ-PD™ PAG1S and EZ-PD™ CCG7DC support PSoC™ MiniProg4 (CY8CKIT-005) as a programmer to program the
EZ-PD™ controllers. The EZ-PD™ PAG1S-based main board and EZ-PD™ CCG7DC-based daughter board can be
programmed using a PSoC™ MiniProg4 five-pin connection.
Figure 4 PSoC™ MiniProg4 (CY8CKIT-005) Programmer Kit
Programming interface and settings
The CYPRESS™ Programmer
an EZ-PD™ PAG1S-based main board and EZ-PD™ CCG7DC-based daughter board. For programming, select the
"CCGx" platform and make other settings, as shown in
Figure 5 Programming interface to program EZ-PD™ CCG7DC 65-W daughter board
User guide
software is used as a programming interface to program the firmware (.hex file) in
Figure 5.
7 002-37406 Rev. *A
2023-04-21