Section 6 − Maintenance; Routine Maintenance; Blowing Out Inside Of Unit - Miller Axcess 300 Owner's Manual

6-1. Routine Maintenance

n = Check
* To be done by Factory Authorized Service Agent
Every Every
l Unreadable Labels
3 3
Months M h
nl Cords
Every
6
Months
~ Drive Rolls

6-2. Blowing Out Inside Of Unit

OM-216 967 Page 26
SECTION 6 − MAINTENANCE
Z = Change ~ = Clean
~ Weld Terminals
nl Gun Cables
OR
~ Inside Unit
Y Disconnect power
before maintaining.
l = Replace
l Damaged Gas Hose nl Weld Cables
.
Maintain more often
during severe conditions.
Reference
Y Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers as
shown.
803 667-A