16.
Gently press down the power cable in the indicated area so that the power cable does
not extend higher than the riser card.
Leaving the power cable extending higher than the riser card will prevent the chassis cover
from closing properly and may damage the power cable.
17.
Repeat steps 1 to 16 for the other GPU cards on riser card 2 and 3.
18.
Check the indicated areas and see if the riser card and GPU card assemblies are
touching or crushing other cables in the server system, then close the chassis to
complete.
Due to the physical limitation of the server system, the riser card and GPU card assemblies
might touch or crush other cables in the server system, and may cause interference with
the signals or damage the other cables.
2-32
Chapter 2: Hardware Setup