Aquathin Platinum-90 Getting Started page 33

several more tubes from their fittings.
5. Disconnect the tubing from each end of the
Aquathin De-ionization (DI) Module. Note the
direction of the "FLOW" arrow. You will need to
install the new DI module in the same orientation.
6. One end of the Aquathin reverse osmosis module
has two connections—one blue tube connects to the
Aquathin DI Module, and one black tube connects
to the Aquathin drain valve assembly. Remove the
black tube from the RO Module.
7. You can no w
remove the two
wing nuts which
secure the
Module and
module to your
Aquathin cabinet.
See figure 19.
8. You are now ready to remove the RO Module and
DI Module from the housing.
Note: If this is the first time you are replacing the
DI Module, you will find both the DI Module and
RO Module are secured to the clamps with double
sided adhesive tape (installed to prevent shifting
and damage during transit). The adhesive will
release if you carefully, and slowly, rotate the DI
Module away from the clamp. It is not necessary to
replace the adhesive when re-assembling the
system.
9. Place the new Aquathin DI Module into the
housing. Re-insert the tubing which connects the
reservoir to the DI Module, taking care to attach the
tubing to the outlet end of the module.
10. Replace the RO Module and clamps. Re-insert the
33 © 2007-2016 Aquathin Corporation. All rights reserved.
RO
DI
Figure 19: Remove the two
wing-nuts