Table of Contents
Advertisement
being shipped across country, we have inserted
small plastic retaining clips on each fitting. These
are easily removed with your fingers or, if grabbing
the clip is difficult, you may wish to use a pair of
needle-nose pliers.
2.
Remove the retaining clips from each end of the
Aquathin CARB 12 pre-filter, then remove the
tubing itself. You will feel some resistance as the
tubing slides away from the O-ring inside the
fitting.
3.
With the CARB 12 free of its connections, it can
now be removed from the two "Double C" clamps
holding it to the RO Module. Note the direction of
the "FLOW" arrow. You will need to install the
new CARB 12 pre-filter in the same orientation.
Refer to Figure 18 for steps 4—6.
4.
After removing the CARB 12, you can easily
remove the two "Double C" clamps and set them
aside. With the CARB 12 pre-filter removed, you
now have access to the Aquathin DI Module and the
RO Module.
(5) remove tubing from
These
two
DI Module
modules are
a t t a c h e d
w i t h
a
c u s t o m
c l a m p
arrangement
secured
by
two
wing
nuts. Before
(6) remove
r e m o v i n g
black tube from
the
wing
Figure 18: Steps 4-6
nuts,
you
NOTE: the
n e e d
t o
the flow for each module
d i s c o n n e c t
32
© 2007-2016 Aquathin Corporation. All rights reserved.
(4)
remove Double C
RO
clamps
green arrows
show you
Advertisement
Table of Contents
