Check Engine Indicator; Error Codes, Engine - Polaris RZR RS1 2019 Owner's Manual

PROGRAMMABLE SERVICE INTERVAL
The service interval counter is programmed to 25 hours at the factory. As hours
of engine operation increase, the counter decreases. The wrench icon will flash
for about 10 seconds when the counter reaches zero (0), and each time the key
is turned on thereafter, until the counter is reset.
When this feature is enabled, it provides a convenient reminder to perform
routine maintenance. Refer to the Periodic Maintenance Chart for recommended
service intervals.
Use the following procedure to reset or change the service interval.
1. Press and hold the MODE button to
enter the settings menu.
2. Press either toggle button to cycle to
the "Service Hours" option. Press
MODE to select.
3. Press MODE to reset the existing
value and exit, or press either toggle
button to change the value. Press
MODE to save and exit to the
settings menu.
ENGINE ERROR CODES
The error screen displays only when the CHECK ENGINE indicator is on or
when it goes on and off during one ignition cycle. Error codes are not stored.
When the key is turned OFF, the code and message is lost, but will reappear if
the fault reoccurs after restarting the engine.
If the CHECK ENGINE lamp or the EPS lamp illuminates, retrieve the active
error codes from the display.
q
Failure Mode Indicator (FMI)
w
Suspect Parameter Number (SPN)
e
Code Count
1. Press and hold the MODE button to enter the settings menu.
2. Press either toggle button to cycle to the "DIAGCODE" option. Press MODE
to select.
FEATURES AND CONTROLS
45