Page 1
VCM34 VCM38 CPW90 Connecting and Pairing VCM34: Do one of the following to connect the VCM34 to MeetingBar AX0. Connect the VCM34 to the VC Hub/Phone port on the MeetingBar AX0 using a network cable: ...
Page 2
Connecting to Audio Input Devices l If AX0 needs to connect multiple VCM34 and VCH51 at the same time, it needs to use a PoE switch, as shown in the following figure: ...
Page 3
Connecting to Audio Input Devices Note: VCM34 can support cascading. Please refer to the table above for the maximum number of cascades when connected to MeetingBar AX0. VCM38: Do one of the following to connect the VCM38 to MeetingBar AX0. Connect the VCM38 to the VC Hub/Phone port on the MeetingBar AX0 using a network cable: ...
Page 4
Connecting to Audio Input Devices l If AX0 needs to connect multiple VCM38 or VCH51 at the same time, it needs to use a PoE switch, as shown in the following figure: ...
Page 5
Connecting to Audio Input Devices CPW90: 1. Insert the DD10 into the USB port on the left side of the MeetingBar AX0. The MeetingBar AX0 display interface or CTP18 prompts "Wireless microphone is connected". 2. On the CTP18, tap Settings > General > System Settings > User Settings > Wireless Microphone >...
Page 6
Connecting to Audio Input Devices 3. Place the CPW90 on the charging base, press and hold the Mute button for 5 seconds, the Mute button LED flashes orange quickly, and it enters the pairing state. The pairing is successful when the CTP18 interface displays the wireless microphone information. Setting Audio Input Device On the CTP18, tap Settings >...