Advertisement
40MHHA: Owner's Manual
Manual Operation (Without Remote Control)
CAUTION
The MANUAL button is intended for testing purposes and emergency
operation only. Do not use this function unless the remote control is lost and it
is absolutely necessary. To restore regular operation, use the remote control to
activate the unit. Unit must be turned off before initiating the manual
operation.
Use the following steps to operate the unit manually:
1. Open the front panel of the indoor unit.
2. Locate the MANUAL CONTROL button on the right-hand side of
the unit.
3. Press MANUAL CONTROL one time to activate the FORCED
AUTO mode.
4. Press MANUAL CONTROL again to activate the FORCED
COOLING mode.
5. Press MANUAL CONTROL a third time to turn the unit off.
6. Close the front panel.
Fig. 11 — Range
NOTE: DO NOT move the louver by hand. Doing so takes the louver
out of sync. Should this occur, turn off the unit and unplug it
for a few seconds, then restart the unit. Doing so resets the
louver.
CAUTION
DO NOT put your fingers in or near the blower and suction unit side of the
unit. The high-speed fan inside the unit may cause injury.
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
Deflector
rod
Fig. 12 — Deflector Rod
Manual Control Button
Fig. 13 — Manual Control Button
10
Advertisement
