Bissell CLEANVIEW 1831 Series User Manual page 9

Maintenance: Brush & Belt
1
Unplug vacuum, turn over and unscrew
six (6) Philips head screws to remove
the bottom cover.
3
Belt
End Cap
NOTE: If an object becomes lodged in foot and brush shuts o , turn vacuum o and
unplug from electrical outlet. Remove obstruction and brush will automatically reset when
vacuum is plugged and turned back on.
Maintenance: TurboBrush
1
2
Align
Slot
Remove brush roll,
Twist gray collar
belt, and paddle
counter clockwise,
wheel. Inspect
until slot appears,
for damages and
then separate
replace if necessary.
faceplate.
Clean debris from
2
brush roll. Inspect
by placing it on its
end and spin. The
brush roll should
spin freely, multiple
times by one flick.
If it doesn't, replace
brush roll.
Check belt for wear
or cuts and replace
if necessary.
Thread belt and line up
End Cap to reassemble
roller. Replace bottom
cover and 6 screws.
®
& TurboEraser Tool
®
3
Paddle Wheel
Clip
Paddle Wheel End
To reassemble, align two clips on each
end of paddle wheel with belt on and
pop back into place.
Place brush roll with belt back in.
Faceplate will not close properly if all
parts are not aligned correctly.
www.BISSELL.ca
Roller
Belt
9