BOMANN GSP 849 Instruction Manual page 6

• Take care of a solid and horizontal position of the appliance. If the appliance is not horizontally leveled,
adjust the feet accordingly.
• Power cable and water hoses may not kinked or squashed.
• Avoid the installation: Avoid the installation: Avoid the installation: Avoid the installation:
near heaters, next to a stove, direct sunlight or any other heat sources;
-
at locations with high humidity (e.g. outdoors), as metal parts would be susceptible to corrosion under
-
such circumstances;
in rooms where the temperature could drop below freezing. Do not expose the appliance any weather.
-
near volatile or flammable materials (e.g. gas, fuel, alcohol, paint, etc.).
-
Water connection Water co nnection
Water co Water co nnection nnection
CAUTION: CAUTION: CAUTION: CAUTION:
• The Installation of the water supply must conform to the local laws and regulations.
• Use the new supplied hose set to connect the appliance to the water supply. Do not reuse old or used
connection sets.
• If the water pipe is new or long time not used, ensure before connecting to the water system, that the water
is clear and free from contamination.
Notes on inlet Notes on inlet hose safety system ( hose safety system (included in delivery)
Notes Notes on inlet on inlet hose safety system ( hose safety system (
The safety system consists of a double-walled inlet hose. This system guarantees to cut off the water supply
when leakage of the inner hose. Switching off the water supply leads over an electronic contact.
Connect the water Connec t the water inlet inlet hose (cold water connection)
Connec Connec t the water t the water inlet inlet
NOTE NOTE NOTE NOTE: : : :
The water pressure must be between 0.04 and 1 MPa. With higher pressure: use a pressure regulator.
• Connect the water inlet hose to a water thread with ¾". Screw the hose firmly in the direction
of the screw thread; pay attention for a tight fit.
• Connect the other end of the inlet hose to the inlet valve on the appliance back; pay attention
for a tight fit too.
Hot water supply Hot water supply Hot water supply Hot water supply
The dishwasher can be supplied with a water temperature of not more than 60°C. Supplying the appliance
with hot water, the rinse running time is shortened but the cleaning effect can be slightly reduced. The con-
nection to the hot water valve must be done in the same manner as described for the cold water connection.
Connect the water drain hose Connect the water drain hose
Connect Connect the water drain hose the water drain hose
NOTE NOTE NOTE: : : : NOTE
The drain hose has a length of approx. 1.5 m and can extend with a suitable hose and connecting piece to a
length of max. 4 m.
included in delivery)
included in delivery) included in delivery)
hose (cold water connection)
hose (cold water connection) hose (cold water connection)
6