Table of Contents
Advertisement
7 7 7 7 Button to activate the ½ load function. At a loading of about or less than half load place settings; energy
and water consumption will be reduced.
NOTE
NOTE: : : : The function is not available for the rinse program
NOTE
NOTE
8 8 8 8 The process lamps shows the status of the rinse program: Pre-rinse->Main rinse->Rinse->Drying->End
Starting a rinse
Starting a
Starting a
Starting a
rinse
rinse
rinse program
program
program
program
• The water supply must be opened up to the maximum pressure.
• Load the dishwasher baskets.
• Fill in the detergent.
• Press the power button to switch on the appliance.
• Select the desired rinse cycle.
• Set the available options, if required.
• Close the appliance door and the dishwasher starts.
Program change
Program change
Program change
Program change
CAUTION:
CAUTION:
CAUTION:
CAUTION:
A program change should be done only a short time after starting the program. Otherwise, maybe detergent
has been released and already drained rinse water.
• To do a program change, open the appliance door carefully so that you can operate the control panel.
Press the program selection button for several seconds.
• Select the wanted program and close the appliance door to start the new operation.
Forg
Forgot to add a dish?
Forg
Forg
ot to add a dish?
ot to add a dish?
ot to add a dish?
WARNING:
WARNING:
WARNING:
WARNING:
Open the door very carefully during operation, there is a risk of water squirting out.
Dishware can be added any time before the detergent dispenser opens.
• Open the door carefully a little.
• Once the spray arms stopped working, you can
open the door completely.
• Add forgotten dishware.
At the end of program
At the e
nd of program
At the e
At the e
nd of program
nd of program
CAUTION:
CAUTION:
CAUTION:
CAUTION:
Allow the appliance to cool down a bit after the program has ended, before you open it. This avoids that steam
escapes that causing long-term damages to your furniture.
At the end of the rinse cycle will sound a series of signals; then the unit goes into standby mode.
Switch off
Switch off
Switch off
Switch off
• Open the appliance door and switch off the appliance by pressing the power button.
[Rapid].
• Close the door.
• After approx. 10 seconds the operation will be
continued.
14
Advertisement
Table of Contents
