BOMANN GSP 849 Instruction Manual page 16

Cleaning the filter system Cleaning the filter system
Cleaning the filter system Cleaning the filter system
CAUTION: CAUTION: CAUTION: CAUTION:
• The dishwasher must never be used without the filter.
• Improper replacement of the filter can reduce performance and damage the appliance.
• Do not knock out the filter for cleaning to avoid possible deformations of the filters.
NOTE: : : : NOTE NOTE NOTE
Check after each rinsing the filter for residues.
• Turn the coarse filter counterclockwise and remove the whole filter system upwards.
• Remove the coarse as well as the micro filter from the main filter.
• Remove leftover food and clean the filters under running water. Use a soft brush, if neces-
sary.
• Put the filter system properly in reverse order together and reinstall in its provided posi-
tion. Fix the entire system, by tightening the filter unit clockwise.
Cleaning the spray arms Cleaning the spray arms Cleaning the spray arms Cleaning the spray arms
Lime and impurities from the rinsing water can block nozzles and bearings of the spray arms. Check the outlet
nozzles of the spray arms regularly for blockages.
• Unscrew the securing nut of
Pull off the lower spray arm upwards.
•
Clean the arms under running water; if necessary use a soft brush for the nozzles.
•
Insert the spray arms again until they clicks into place and tighten the nut of the upper
•
spray arm.
Maintenance of the dishwasher Maintena nce of the dishwasher
Maintena Maintena nce of the dishwasher nce of the dishwasher
CAUTION: : : : CAUTION CAUTION CAUTION
Never use spray cleaners to clean the door panel, this may damage the door lock and electrical components.
• Clean the appliance outer surfaces and the door sealing thoroughly with a soft, damp cloth. Use only mild
cleaning agent.
• Use to remove stains inside the appliance a dampened cloth with a little white vinegar or a special deter-
gent for dishwashers. If necessary, fill detergent in and start the appliance without dishware in the program
with the highest rinse temperature.
• Dry the outer surfaces thoroughly before taking in operation again.
A A A A ntifreeze ntifreeze protection ntifreeze ntifreeze protection protection protection
If the unit is out of operation and exposed to temperatures below zero, observe the following precautions:
• Disconnect the mains plug.
• Close the water supply and remove the inlet hose from the water valve.
• Drain the water from the inlet hose and the water valve.
• Reconnect the inlet hose to the water valve.
the upper spray and pull off the arm downwards.
16