Table of Contents
Advertisement
Installing the Power Connector
1.
Insert the power connector into its slot on the system board and guide the cable into the retention
tabs.
2.
Connect the power connector cable to the system board.
3.
Install:
a.
system board
b.
base cover
c.
keyboard
d.
memory module
e.
hard drive
f.
WLAN card
g.
access panel
h.
optical disk-drive
i.
battery
4.
Follow the procedures in
Removing the Display Assembly
1.
Follow the procedures in
2.
Remove:
a.
battery
b.
optical disk-drive
c.
access panel
d.
hard drive
e.
memory module
f.
keyboard
g.
system board
3.
Perform the following steps as shown in the illustration:
a. Unroute the WLAN antenna cables [1].
b. Remove the screws that secure the display hinges to the chassis [2].
24
After Working Inside Your
Before Working Inside Your
computer.
Computer.
Advertisement
Table of Contents
