1
Installing the Handle
Parts needed for this procedure:
1
Handle
Procedure
1. Remove the flange lock nut from the bolt and pivot
pin on each side of the mower (Figure 4).
1. Flange lock nut
2. Insert the handle ends through the slots in the handle
support arms (Figure 5).
1. Left handle end
2. Support arm
3. Squeeze the handle ends inward and install them on
the step of the pivot pin (Figure 5).
Figure 4
2. Pivot pin
Figure 5
3. Pivot pin
4. Locknut
4. Secure the handle to the bolt and pivot pin with the
flange lock nut (Figure 5).
5. Locate cable tie loosely securing throttle cable to
wire harness. Position cable tie approximately one
inch behind transmission and tighten cable tie.
2
Adjusting the Handle
No Parts Required
Procedure
1. Remove hairpin cotters from ring pins on each side
of mower (Figure 6).
1. Ring pins
2. While supporting handle, remove ring pins from
each side and raise or lower handle to desired
operating position (Figure 6).
3. Reinstall ring pins and hair pin cotters.
10
Figure 6