Operation Panel; Functions Of Buttons - Clarion NX706AU Owner's Manual

4. OPERATION PANEL

[VOICE]
[IR]
Only navigation map card is available and don't remove it when unit is powered on

Functions of Buttons

[MAP/ Power] Button
• Press this button to turn on the power.
• When the power is already on, it moves to the
Navigation mode. If Navigation mode is displayed, it
stays on the Navigation mode.
• Press and hold down this button for 2 seconds to
turn off the power.
[NAVI/AV] Button
• Press this button to display the Navigation mode,
press again to return current source.
• Press and hold this button for 2 seconds to display
the Dimmer setting menu.
[MENU] Button
• Press this button to display main menu; press again
to return current source.
• Press and hold this button for 2 seconds to turn off
the monitor. Press anywhere on the touch screen to
turn on the monitor again.
[RESET] Button
• Press this button to hardware reset the unit.
Note:
When the [RESET] button is pressed, frequencies of radio
stations, titles, etc. stored in memory are cleared.
NX706AU
10
AU
[MENU] [MAP/ Power]
[RESET] [NAVI/AV] [-VOL+]
[Microphone]
• This is used for Bluetooth phone functionality.
[IR] SENSOR
• Receiver for the remote control unit (operating range:
30 degree in all directions).
[VOICE] Button
• Press and hold this button until you hear the tone,
®
then you can use Siri Eyes Free function.
[Open/Tilt] Button
• Press this button to open and close the panel.
• Keep pressing this button more than 2 seconds in
order to change the tilt angle.
[-VOL+] Button
• Press these buttons to increase or decrease the
volume level.
• Keep pressing one of these buttons for more than 2
seconds to quickly increase or decrease the volume
level.
[Open/Tilt]
[Microphone]