Finishing Pressing - Pyle PSTMP95 User Manual

STEP 7 - FINISHING PRESSING/STORING THE UNIT
a. Water may be left in the reservoir , because it will not drip out if the
machine is stored in an upright position. However, it is recommended that
if the machine will be stored for some time, that all the water in the unit
should be drained by pressing the Steam Burst Button until all of the water
is pumped out.
b. Press the [ POWER ] button, the Red Power Light will go out. Disconnect
the plug from the outlet. Leave appliance in open position.
c. Wait for the Steam Press to cool completely (approximately 30 minutes).
d. When cool, lower the Pressing Plate onto the Ironing Board pushing the
handle to its lowest position.
e. Turn the Locking Knob to the locked position. This should prevent the
Steam Press from opening while being moved or stored.
f. Loosely wrap the electric cord and place it in the opening at the front of the
base of the Ironing Board. You are now ready to store the unit.
9