Table of Contents
Advertisement
STEP 6 - PRESSING
a. Lift the Pressing Handle (A). The Pressing Plate (B) moves to the up
position.
b. Carefully arrange the garment to be pressed onto the Ironing Board (C).
c. Grasp the handle of the Pressing Plate(A) and lower it onto the Ironing
Board (C), capturing the garment between the two halves of the Steam
Press. For light duty Pressing, simply lowering the handle and allowing the
Pressing Plate to rest on the Ironing Board will be sufficient. Return to the
open position.
and press downward until the Pressing Plate is pushed to its lowest
position, then open the press.
d. If the temperature is set high enough you may give the fabric a burst of
steam by pressing the Steam Burst Button (D) to remove stubborn
wrinkles. Lower the pressing plate until it is about two inches from the
garment. Press the Steam Burst Button for about 3-5 seconds. After
releasing the Steam Burst Button you may fully lower the pressing plate.
NOTE: Do not press the Steam Burst Button when the pressure
plate is in its lowest (closed) position.
e. After a few seconds, lift the handle and raise the Pressing Plate back to the
raised position.
A
IMPORTANT NOTE: If you forget to raise the Pressing Plate or become
distracted, the machine will give a warning beep and automatically shut-off
heating after approximately 10 seconds. The steam press will be completely
shut-off after 15 minutes of no activity with the press in the open position.
For heavier duty pressing, continue to grasp the handle
B
D
8
C
Advertisement
Table of Contents
