Description Speedcontroller; Charge Battery Pack; Inserting The Drive Battery - Carson Mountain Warrior MC-10 Instruction Manual

DeScrIPtIon SPeeDcontroLLer

We recommend for the operation of the built-in model speed
controller the LiFe drive battery which is included in delivery. But
you can use also 7.4V LiPo and 7.2V NiMH drive battery. You must
change the located Jumper on the controller.
One is for LiFe/LiPo- and other is for NiMH battery used. This is
absolutely necessary, since the drive battery is otherwise damaged:
BATT jumper to left:
BATT jumper to right:
About the TYPE jumper you can be select whether in normal mode
(ESC) or in the crawl mode (active brake) is to be moved.

cHarge battery PacK

Beware:
For charging the battery, only use the recommended charger. Please
consider the advice of the enclosed instructions.
Charging procedure:
1 Connect the plug-in charger to wall socket.
2 Connect the battery to the charger.
3 Battery is fully charged when the status LED changes to green.
ATTENTIoN!
Never recharge the battery unattended.
You can use also 7.4V LiPo- and 7.2V NiMH batteries in your car be
operated.

InSertIng tHe DrIVe battery

1 Remove the bodywork.
2 Insert the battery into the designated compartment.
3 Secure it with the available hook-and-loop strap.
Advice
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before
being charged.
• Rechargeable batteries are only to be charged under adult
supervision.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Regular examination of transformer or battery charger for any
damage to their cord, plug, enclosure and other parts.
GB // 14
LiPo battery
NiMH battery