Sound And Vibration; Before Starting The Equipment - EINHELL BT-PO 1100 E Original Operating Instructions

Anleitung_BT_PO_1100_E_SPK1:_
GB

Sound and vibration

Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Vibration emission value a = 13,35 m/s
h
K uncertainty = 1,5 m/s 2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
5.1 Assembly (Fig. 3-6)
Important! Pull out the mains power plug before
starting the assembly work.
10
12.05.2010 13:04 Uhr Seite 10
6. Starting up
6.1 Using as a polishing machine
When using waxing and polishing agents,
observe the instructions issued by their
manufacturer!
84 dB(A)
3 dB
IMPORTANT!
95 dB(A) To prevent damage to the surfaces of the workpieces
you wish to polish, make sure that you observe the
3 dB
following instructions:
Make sure that the polishing attachment is always
mounted precisely in the center of the
sanding/grinding disk.
Before you start the equipment, check to ensure
that the attachments are securely installed.
Never touch the area you wish to polish with the
edge of the sanding/grinding disk.
2
Use the speed selector (Fig. 2/Item 4) to select the
following maximum speeds for polishing:
- Working in polish:
- Polishing to a high gloss: approx. 1000-1100 rpm
- Polishing up:
If you do not comply with these instructions, the
manufacturer cannot accept any liability.
The Velcro fastener enables easy changing of the
polishing attachment.
- Use the foamed plastic attachment to apply the
polishing agent (Fig. 7).
Make sure that the foamed plastic attachment is
free of any foreign bodies.
Spread the polishing paste evenly over the
polishing pad. Do not apply the polish directly to
the polishing surface.
Switch the polishing machine on and off only
when the polishing machine is resting on the
polishing surface.
Place the extension lead over your shoulder and
work first on the large, flat surfaces such as the
bonnet, boot lid and roof.
Keep your movements as regular as possible.
Important! Allow the polishing machine to glide
over the polishing surface. Do not exert pressure!
Work next on the smaller surfaces (doors, for
example)
Use the fleece attachment to finish off the
polishing (Fig. 8).
Make sure that the fleece attachment is free of all
foreign bodies.
Remove the layer of polish in the same order as it
was applied.
Important! Do not exert pressure on the
polishing machine!
approx. 1000 rpm
approx. 1400 rpm