LG - 86TR3DK-B User Manual page 9

CAUTION
• Do not install the product in a place with electromagnetic interference.
• If the product is installed in a special place other than the normal conditions of use, serious problems may occur in
image quality, lifespan, and appearance due to the influence of the surrounding environment. Please make sure to
check with our service personnel before installation. Be careful of unwarranted conditions and places such as places
where lots of fine dust is generated, places where lots of oil mist is generated, places where chemicals are used,
places exposed to direct sunlight, places where the temperature is too high or too low, and places with high humidity
when installing the product.
• Place the product a minimum distance (100 mm) away from the wall to ensure good ventilation.
- If it is installed too closely to the wall, it may cause product damage or fire due to a rise in internal temperature.
• When the power cord is connected, make sure that the vents are not blocked by tablecloths, curtains, or other
objects (such as plastic).
- It may be deformed or fire can break out due to internal heat.
• Do not install it in a place where ventilation is not available (such as a bookcase or closet), or in a separately created
outside place, or on a carpet or a cushion.
- Fire can break out due to internal heat.
• Install the product in a flat, secure place, and in a place sufficiently strong to support it.
- If the product falls, it may cause personal injury or product damage.
• When installing the product on a shelf or cabinet, make sure that the bottom end of the product is not protruding
forward.
- The product may fall due to unbalanced centre of gravity, which may cause personal injury or damage to the
product. Be sure to use cabinets or shelves that fit your product.
• An easily accessible power disconnection device must be installed in the indoor wiring circuits.
• Components that comply with the requirements of IEC 61643 must be provided inside or outside the product.
• When installing the product outdoors, set the mode to [Screen Off & Backlight (Outdoor mode)].
- Enable the [Outdoor mode] to reduce the risk of the internal humidity and condensation.
• When the temperature is below zero, the product may fail to start operating within one hour as the temperature
needs to be raised in the enclosure first.
9