Table of Contents
Advertisement
aution:Do not start more than two machines at the same time. The
machines should be started one ty one. Do not use the floodlight at
the same time when using other devices.
4. When connecting devices to the generator, make sure to connect these dev . i ces in
order.Connect the large loads onto the generator first. If everything is functional
mailer loads can then be added. If the generator shuts off, it may be because th
load being drawn by all the various devices are too high. In this
the number of small devices until
hould not exceed
1-1 for technical specifications of what the generator can output. In order to reset
the generator after overdrawn power, let it sit for several minutes. If the
tion of the voltemeter is too high or too low, adjust the speed accordingl
are problems, stop the generator immediately and fix the
S.
Make
sure you are
tor should never be covered with anything to prevent overheating the generator.
2-6.3 Charging the battery
I. For the electric starter generator, the 12V battery is automaticall
the regulator on the generator when it is running.
2. If the generator is not used for long periods of time,
nected to avoid
energy
3. Do not connect the negative and pos山ve terminals of the battery together at any
time. Doing so will damage the battery
4. Do not reverse the polarities when attaching the battery cables to the battery.
Doing so will damage both tbe battery and
5. When charging the battery, the battery produces flammable gases. Do not smoke,
flames, and sparks
To avoid sparking while connecting the cables to the
cables to the battery then to the motor, To disconnect battery cables, first
nect
the
motor end of the cable.
everything
the
maximum output power of the
operating
your generator in a well-ventilated area.
loss from the battery.
get
near the batter
y
is functional. The total drawn power
generator.
issue.
the battery
the
electric starter.
while it is charging as this may cause a
battery,
11
event,
decrease
Please see Table
indica
. lf there
y
The
genera
charged through
y
should be discon
fire
first, connect the
discon
Advertisement
Table of Contents
