Bison BS3500DSE Owner's Manual page 13

do n't put the rubber
rain, dust and other d.1rt can enter into
the diesel engine. It will cause the parts
inside the diesel engine to wear quickly
and lead to engine failure.
rubber
cock
2-4.2 Electric sta巾ng
The procedures for preparing to start eh
gine are the same as the manual starting
eng111e.
2-4.3 Battery
l. Insert key into i g nition and put it in
the "off position.
2. Put the speed
position.
3. Turn the start switch clockwise to the
""TART" position; To set the silent
type, first turn it clockwise to the "RUN"
(ON) position for 1-2 seconds. The
lectromagnetic iron will be triggered,
now tum it clockwise to the "START"
position.
4. After the diesel engine is started, re­
move your hand什om the switch handle;
the switch will automatically
to the "ON" position.
5. lf the engine is not starting after I 0
econds of cranking,
econds before
crank to long, the voltage of the battery
will drop. This can
ignition. When the diesel engine is
operating,let the ignition retain on the
'ON" position.
plug back in place,
en­
。
handle in the "Run"
reset itself
wait about 15
trying it again.
If you
lead to improper
speed
handle
ote:
If you crank the starter to long,
the battery may be drained too
much to provide enough
for proper engine ignition. Also,
when the
o perating, let the key retain in
the "ON" position.
Check the height of the electrolytic
solution in the battery once a month.
If the level of the liquid drops to low
fill it with distilled water until it
reaches the high mark. If there is not
enough electrolytic
diesel engine cannot be started. 1t is
important to keep the liquid
ween the high and low limits. ff the
level in the battery is too high
liquid may flow out and end up on
surrounding parts resulting in corrosion
of these parts.
ote: Avoid too much or to little of
electrolytic solution. Check and fill it
once a month
9
...
ene rg y
diesel engine i
solution, then the
level
、
-
2
-
bet­
the