Starting The Generator Set - Bison BS3500DSE Owner's Manual

but the engine off. The purpose of
having this system is to ensure that
the engine does not seize up. If there
is not enough oil in the engine, th
temperature of the oil will be raised
too high. O n the con
too much oil in the engine,the engine
oil can slow the engine down
considerably.
(Note: The 2 GF-L model cannot au­
tomatically stop itself)
2-3.2 How to open the case door/cover
( 1 ) O pen the case door:
counterclockwise and open the door.
Do these checks daily.
．冒
「.—
Loosen the outer cover bolt of the air fil­
(2)
ter and outer cover of the oil nozzle, and
then check the air filter.
Check the outer cover of the oil nozzle.
(3)
Loosen the butterfly nut and open the
outer cover.
Rubb er
cock
2-3.3 Engine break in
When you purchase a brand new
engine, the engine must be properly
broken in.The break in period is about
20 hourv.
(1) Avoid overloading the engrne
when brand new.
ary, if the
甘
代
the handle
tum
··
.l�
邑
Knob handle
(2) Change the engine oil according
to specifications.An oil change for a
brand new engine is about 20 hour
or eve1y month, an older engine, the
oil change is about 100 hours or three
1
months.

2-4 Starting the generator set

2-4.1 Manual starting.
tart the engine in accordance with
procedures below:
Put the伈el switch in tbe
(1)
position.
扣el switch
(2) Turn the handle of the engine to
the "RUN" position.
peed
handle
(3) Pull the recoil starter handle out
until you feel resistance. It will reset
to its original position automatically.
The handle should be reset into it
recoil device slowly to prolong the
life of the life of the engine starter.
( 4) In cold climate, it is difficult to
tart the engine. To remedy this, pull
the rubber plug out from the rocker
of the diesel engine and fill 2 ml of
engine oil. Before starting, put the
rubber plug back in place. lf you
8
"Q1'T"
尸
＂
．
－
｀ 多 伊