Bosch X-LOCK GWX18V-10P Operating Instructions Manual page 23

Masonry Cutting Guard Assembly
A type 27 grinding wheel
guard may not be used for
all tool operations. Do not discard guard when
not in use. Always reinstall wheel guard when
converting back to grinding operations.
For cutting masonry, gearbox must be rotated
relative to the position of the switch as the tool
was assembled at the factory.
Rotate Gearbox:
1. Completely unscrew the four screws be-
tween the gear housing and motor body.
2. Rotate gear housing 90 degrees, so the
Paddle Switch (Fig. 16, 2) is facing the
workpiece.
3. After adjusting the position of the gear
housing, screw in and tighten the four
screws.
4. The screw holding the Guard Release Lever
(11) is longer than the other screws (Fig.
17), this long screw must stay with the
Guard Release Lever (11) when re-attach-
ing gear housing for the Guard Release
Lever (11) to operate properly.
5. To install proper guard follow instructions
in the next section.
Installing a Masonry Type 41/1A Cutting
Guard
Follow all instructions provided with the ma-
sonry Type 41/1A cutting guard to install and
use it with this grinder.
Installing Dry Diamond Wheel
Follow all instructions provided with the ma-
sonry Type 41/1A cutting guard to prepare it
for installation of compatible accessories and
operation.
To install Dry Diamond Wheel (Fig. 18) see in-
structions on page 18.
Assembly
Fig. 16
DEGREES
Fig. 18
-23-
90
(2)
(under
tool)
90
DEGREES
Fig. 17
(11)
Dry Diamond
Wheel