M Vision CINE 400-3D Service Manual page 52

4.7 Firmware download procedure for RJ-45(Micro Control BD) IC315
1. Connect the AC power of the projector and powon on projector
2. Connect the RJ-45 cable between the projector and the PC.
And make sure that the two LEDs of the RJ-45 module are lit after
connecting the RJ-45 cable between the PC and the projector.
3. Properly setup the IP for the PC and make sure that the PC and the
projector are in the same subnet. For example, the default IP of the
projector is 192.168.0.100.
4. So the IP of the PC should be set as 192.168.0.15 for example.
Double Click