Description Of 2.4 Ghz Remote Control System - Carson SA315 B Lama Instruction Manual

d. Description of 2.4 GHz Remote Control System
1. Product information
The Carson 2.4 GHz system finds a free transmitting frequency
automatically, so does not need to be equipped with the
transmitter and receiver crystal that are normally required.
Synchronisation
button
Transmitter
2. Connection
diagramm
Transmitter
3. Calibrating the 2.4 GHz system
To synchronise the transmitter with other receivers, please
following the following procedure:
1. Put batteries / accumulators into the 2.4 GHz transmitter and
switch it off.
2. Insert the synchronisation cable into one of the receiver's
two servo slots (Illustration 1).
3. Connect the battery lead to the receiver (Illustration 1).
The 2 LEDs begin to flash and confirm the "match" status for
synchronising the transmitter and receiver.
4. Press and hold down the SET button on the transmitter, then
switch the ON/OFF switch on the transmitter to ON
(Illustration 2).
5. Release the SET button on the transmitter and remove the
synchronisation cable from the receiver.
NOTE!!!
The built-in components are already coordinated. These must
not be re-synchronised.
Receiver unit
CH 1
CH 2
6. Check the LEDs on the receiver. If the LEDs are no longer
flashing, the synchronisation process has been successfully
completed. However please wait for a further 10 seconds.
7. Connect the servo plug to the receiver and check that it
works (Illustration 3).
8. If the test is not successful, please repeat the procedure
starting at point 1.
9. If the test is successful the accumulator pack may be
reconnected to the accumulator plug.
The synchronisation of the transmitter and receiver is now
complete.
CARSON SA315 B Lama 1:16
Battery
Receiver unit
13
GB