Four Channel Remote Control Transmitter - Carson TRIPLE TWO Wolff 507022 Instruction Manual

c. Four channel remote control transmitter
Included in the scope of delivery is a remote control
transmitter with two remote control levers, which are assigned
the two respective functions.
These functions are activated by the movements forwards /
backwards and right / left.
AA X 8 batteries are required for the
transmitter (not included)
Trim lever pitch
Pitch (Lift)
Tail (Rudder)
Trim lever tail
Transmitter crystal
Functions on the back of the transmitter:
• Charging socket
• Battery chamber
Dual rotor blades' speed adjustment via
PCB control
Warning!!! Please work very carefully, applying minimal
pressure and using a small screw driver.
1. Function of button: adjust upper and lower rotor blades'
different speed.
a. Turning the button clockwise, upper rotor blade runs
faster and helicopter turns left.
b. Turning the button anti-clockwise, lower rotor blade runs
faster and helicopter turns right.
2. The "PCB CONTROL" is properly adjusted when the
helicopter no longer drifts in any direction.
Put the charged batteries in the battery compartment of the
transmitter.
Telescopic antenna
CARSON Helikopter TRIPLE TWO Wolff 507022
Pay attention to the correct polarity!
4 Reverse switch for tail rotor
3 Reverse switch for acceleration
2 Reverse switch for pitch
1 Reverse switch for roll
Servo reverse switches to change the reaction
direction.
Adjusting screw
Receiver plug tail
rotor function
Receiver plug
accelerator
GB
Trim lever nick
Nick (Elevators)
Roll (Ailerons)
Trim lever roll
ON/OFF switch
11