Table of Contents
Advertisement
repaIrS
During normal flight operation the model is pretty tough, however
all model fliers expect to have to carry out repairs to their models
at one stage or another. The plastic from which the model is pre-
dominantly made can be easily repaired using a two-part adhesive.
During curing the parts must be aligned and bonded against each
other in order to achieve a complete repair.
troubLe SHootIng
problem
Model fails to move
Motor fails to turn
Model fails to climb
the motor cannot be switched off
GB // 28
Never fly a model that has been damaged in a crash if you are
unsure as to whether the repair has restored the aircraft to its origi-
nal condition. There are several parts which cannot be repaired e.g.
propeller, electronic components, operating rods, motor and sup-
port. Replacements should be sourced through your local dealer.
Ursache
1. Check that the transmitter and receiver
are switched on
2. Check the transmitter and receiver battery
charge
3. The trim switch controlling the throttle
sticks in the top position.
Motor is faulty
Motor gets too hot
Batteries are empty
Trim is not set correctly
lösung
Switch the transmitter or receiver on
Insert fully charged batteries
Ensure that the trim switch controlling pitch
is in neutral position or slightly lower.
Replace the motor
Let the motor cool down
Charge or replace the batteries
Correct the trim using the throttle control
Advertisement
Chapters
Table of Contents
