Maintenance - Husqvarna 592 XP Operator's Manual

WARNING:
you cut a tree that is in tension. There is
a risk that the tree moves quickly before
or after you cut it. Serious injury can
occur if you are in an incorrect position
or if you cut incorrectly.
6. If you must cut across tree/branch, make 2 to 3 cuts,
1 in. apart and with a depth of 2 in.
7. Continue to cut more into the tree until the tree/
branch bends and the tension is released.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule
Daily maintenance
Clean the external parts of the prod-
uct and make sure that there is no oil
on the handles.
Do a check of the throttle trigger and
throttle trigger lockout. Refer to
a check of the throttle trigger and
throttle trigger lockout on page 24 .
Make sure that there is no damage
on the vibration damping units.
Clean and do a check of the chain
To do a check of the
brake. Refer to
chain brake on page 24 .
Do a check of the chain catcher. Re-
To do a check of the chain
fer to
catcher on page 24 .
22
Be very careful when

Maintenance

Read and understand the
Weekly maintenance
Clean the cooling system. Refer to
To clean the cooling system on page
33 .
Do a check of the starter, starter rope
To do
and return spring.
Lubricate the needle bearing. Refer
To lubricate the needle bearing on
to
page 31 .
Remove burrs from the edges of the
guide bar. Refer to
the front hand guard and the chain
brake activation on page 23 .
Clean or replace the spark arrester
screen on the muffler.
8. Cut the tree/branch from the opposite side of the
bend, after the tension is released.
Heated handles (592 XPG)
The product has heated front and rear handles. The
electrical heating coils are powered by a generator.
Push the switch in the direction of the arrow to engage
the function. Push the switch in the opposite direction to
disengage the function.
Electrical carburetor heating (592 XPG)
Adjustment of the carburetor heating is done electrically
through a thermostat. This keeps the correct carburetor
temperature and prevents ice in the carburetor.
Monthly maintenance
Do a check of the brake band. Refer
To do a check of the brake band
to
on page 23 .
Do a check of the clutch centre,
clutch drum and clutch spring.
Clean the spark plug. Refer to
amine the spark plug on page 28 .
Clean the external parts of the carbu-
To do a check of
rettor.
Do a check of the fuel filter and the
fuel hose. Replace if necessary.
To ex-
1471 - 001 - 18.02.2021