Operation - Husqvarna 592 XP Operator's Manual

3. Attach the wires to the holder for the Husqvarna
connectivity device.
4. Put the holder for the Husqvarna connectivity device
on the air filter holder and install the 2 screws.
Introduction
WARNING:
safety chapter before you use the product.
To do a function check before you use
the product
1. Make sure that the chain brake operates correctly
and that it is not damaged.
2. Make sure that the right hand guard is not damaged.
3. Make sure that the throttle lockout operates correctly
and that it is not damaged.
4. Make sure that the start/stop switch operates
correctly and that it is not damaged.
5. Make sure that there is no oil on the handles.
1471 - 001 - 18.02.2021

Operation

Read and understand the
5. Connect the connector.
6. Remove in the opposite sequence.
To assemble a spiked bumper
To assemble a spiked bumper, speak to your servicing
dealer.
6. Make sure that the vibration damping system
operates correctly and that it is not damaged.
7. Make sure that the muffler is correctly attached and
that it is not damaged.
8. Make sure that all parts of the product are correctly
attached and not damaged or missing.
9. Make sure that the chain catcher is correctly
attached.
10. Do a check of the saw chain tension.
3 4
6,8
2
10
7
1 9
11