Midea 340457 User Manual page 28

Filling The Rinse Aid Reservoir
The rinse aid is released during the final rinse to prevent water from forming droplets on
your dishes, which can leave spots and streaks. It also improves drying by allowing water
to roll off the dishes. Your dishwasher is designed to use liquid rinse aids.
1. Remove the rinse reservoir cap by
lifting up the handle .
3. Close the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is
designed to adjust the consumption by user. Follow the below steps.
1. Close the door, switch on the appliance.
2. Within 60 seconds after the appliance was switched on press the Program "
button for more than 5 seconds to enter the set model, the rinse aid indication
blinks as 1Hz frequency.
3. Press the Program "
using habits, the setting will change in the following sequence:
d3->d4->d5->d1->d2->d3.
The higher the number, the more rinse aid the dishwasher uses.
4. Without operation in 5 seconds or press the Power button to complete the setup
and exit the setting mode.
" button again to select the proper set according to your
2. Pour the rinse aid into the dispenser,
being careful not to overfill.
27
"