Advertisement
Quick Links
AP-500H-MNTD2 Mount Kit
Installation Guide
The Aruba AP-500H-MNTD2 is a stand-alone desk mount for the 500H Series access points.
Package Contents
Mount Stand
n
(x2) M2.6x0.45x8 Pan Head Phillips Screws
n
(x2) M2.6x0.45x8 Pan Head T8H Torx Screws
n
This mount kit includes two sets of screws - regular Phillips screws and tamper-proof Torx screws. You can choose
whichever set of screws you prefer to secure the mount stand to the access point.
Installation
1. Insert the Ethernet jumper cable to the E0 port on the back of the access point. This Ethernet jumper
cable is pre-installed on the mount stand. See
2. Align the keyholes on the back of the access point to the corresponding posts on the inside of the
mount stand. Press the access point into the mount stand, then slide the access point down until the
posts engage with the keyholes. See
Figure 1 Installing Access Point to Mount Stand
AP-500H-MNTD2 Mount Kit | Installation Guide
Figure
1.
Figure 1
and
Figure
2.
1
Advertisement
Related Manuals for Aruba Networks AP-500H-MNTD2
Summary of Contents for Aruba Networks AP-500H-MNTD2
- Page 1 AP-500H-MNTD2 Mount Kit Installation Guide The Aruba AP-500H-MNTD2 is a stand-alone desk mount for the 500H Series access points. Package Contents Mount Stand (x2) M2.6x0.45x8 Pan Head Phillips Screws (x2) M2.6x0.45x8 Pan Head T8H Torx Screws This mount kit includes two sets of screws - regular Phillips screws and tamper-proof Torx screws. You can choose whichever set of screws you prefer to secure the mount stand to the access point.
- Page 2 Figure 2 Attaching Access Point onto Mount Stand 3. Once the access point is attached to the mount stand, lift the cap on the back of the mount stand, insert and tighten the two included Phillips/Torx screws into the holes, then put the cap back on. See Figure Figure 3 Securing Access Point on Mount Stand 4.