Steps
1
Place the display assembly on a clean and flat surface.
2
Align and place the palm-rest and keyboard assembly on the display assembly.
3
Using the alignment posts, close the display hinges.
4
Connect the display cable to the system board and adhere the tape to secure the display cable.
5
Place the EDP metal bracket on the display cable connector.
6
Replace the two (M2x3) screw to secure the EDP metal bracket to the system board.
7
Connect the touchscreen cable to the connector on the system board.
8
Replace the six (M2.5x4) screws that secure the display hinge to the chassis of the computer.
9
Route the WWAN cable and the WLAN cable through the retention clips provided.
Next step
1
Install the
WWAN
card.
2
Install the
WLAN
card.
3
Install the battery.
4
Install the
base
cover.
5
Follow the procedure in
Display bezel
Removing the display bezel
Prerequisites
1
Follow the procedure in
2
Remove the
base
cover.
3
Remove the battery.
4
Remove the
WLAN
card.
5
Remove the
WWAN
card.
6
Remove the
display
assembly.
About this task
The figure indicates the location of the display bezel and provides a visual representation of the removal procedure.
82
Disassembly and reassembly
After working inside your
computer.
Before working inside your
computer.