Installing The Led Board - Dell P80G Service Manual
Hide thumbs
Also See for P80G:
- Service manual (131 pages) ,
- Quick start manual (2 pages) ,
- Service manual (70 pages)
Table of Contents
Advertisement
Steps
1
Locate the LED board on your computer.
2
Open the latch and disconnect the LED board cable from the system board.
3
Peel back the LED board cable.
NOTE:
The LED board cable is secured to the computer by an adhesive strip.
4
Remove the single (M2x3) screw that secures the LED board to the computer.
5
Lift the LED board out of the computer.
Installing the LED board
Prerequisite
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the LED board and provides a visual representation of the installation procedure.
52
Disassembly and reassembly
Advertisement
Table of Contents
